LEED Green Associate guideStudy & preparation

What Is on the LEED® Green Associate™ Exam? The Current v5 Domains

Published 6 min read3 official sources

Short answer

The LEED® Green Associate™ exam covers eight domains in GBCI's current v5 candidate handbook, led by LEED Process and Energy and Atmosphere at 15 published questions each. The domain counts total 85, while candidates answer 100 multiple-choice questions, including unidentified unscored items. Use the published counts to guide study priorities without treating them as percentages of the full exam or assuming you can identify unscored questions.

Which eight domains are on the current v5 outline?

The LEED® Green Associate™ exam covers eight domains in GBCI's current candidate handbook, with LEED Process and Energy and Atmosphere carrying the largest published counts: 15 questions each. The exam is based on LEED v5, as confirmed by USGBC's preparation guidance and checked November 5, 2026.

The table summarizes the handbook's exam specifications. It is a map of subject coverage, not a substitute for the complete list of objectives.

DomainPublished question countMain study areas
LEED Process15Organizations, rating systems, prerequisites and credits, certification review, resources and impact areas
Integrative Process Planning and Assessments6Early assessments, systems thinking, life-cycle cost, project team and community roles
Location and Transportation9Site selection, existing infrastructure, transportation demand, commuting emissions and connected development
Sustainable Sites8Site assessment, habitat, heat islands, lighting, rainwater and resilience
Water Efficiency10Indoor and outdoor water use, fixtures, irrigation, alternative water sources, leaks and metering
Energy and Atmosphere15Energy loads, envelope and equipment, efficiency, renewable energy, commissioning and greenhouse gases
Materials and Resources11Life-cycle assessment, embodied carbon, purchasing, declarations, reuse and waste
Indoor Environmental Quality11Air quality, lighting, acoustics, thermal comfort, biophilia and accessibility
Total of published domain counts85All eight domains belong in your preparation

Save the current handbook's specifications beside your study notes. Use these official domain names when labeling practice mistakes, so you can see which subjects you have actually reviewed.

How should you read the published question counts?

The domain table totals 85, but the handbook describes a 100-question exam. It also says the exam includes unscored questions that candidates cannot identify. The handbook does not explicitly state the number of those unscored questions in the verified specifications, so do not turn the difference into a claimed official count of 15 unscored items.

Keep three distinctions clear:

  • Published domain counts are content guidance. They show the relative emphasis in the specifications; they do not identify the domain of every item on your particular exam.
  • Counts are not percentages of the full test. Preserve the handbook's published question counts when describing the two largest domains.
  • Counts do not establish a passing threshold. Do not use this table to calculate how many questions you can miss and still pass.

For preparation, a practical use of the numbers is to give a substantial early review to the larger areas, then adjust for your own gaps. During the exam, approach every question as one that matters, because the unscored items are unidentified.

Which areas deserve early attention?

Start by checking your understanding of LEED Process and Energy and Atmosphere, the two domains with counts of 15. Then assess Materials and Resources and Indoor Environmental Quality, with 11 each, and Water Efficiency, with 10. These counts support prioritizing attention; they do not justify skipping the remaining subjects.

Your background should change the sequence. If you already understand building energy concepts but cannot explain prerequisites, credits or certification review, begin with the LEED Process review. If the energy terminology is less familiar, use the Energy and Atmosphere guide to organize that review.

A simple editorial rule is to test your explanation before allocating more reading time: can you describe a concept without notes, apply it to a short project situation, and explain why a different approach would not fit? The handbook identifies recall, application and analysis as the cognitive skills assessed. Repeating a definition alone does not exercise all three.

When comparing preparation options, see how full LEED Green Associate prep, planned for launch, weights practice by domain, alongside your current materials. Use the handbook's coverage as your comparison checklist.

What should you be able to do in each domain?

The following are editorial study tasks drawn from the published scope. They are prompts for reviewing the references, not official exam questions or predictions of what your test will ask.

  1. LEED Process: Draw a simple project certification flow and annotate where rating-system selection, prerequisites, selected credits and review fit. Add a separate note for the roles of USGBC and GBCI. Check every label against the references.
  2. Integrative Process Planning and Assessments: Choose an early project decision and list the team or community perspectives needed to assess it. Explain which other building systems that decision might affect and where life-cycle cost could inform the discussion.
  3. Location and Transportation: Compare two hypothetical locations by existing infrastructure, transportation choices and commuting considerations. Identify the information you would need before reaching a conclusion instead of declaring a winner from one feature.
  4. Sustainable Sites: Make a site-review checklist with habitat, rainwater, heat islands, exterior lighting and resilience. For each item, write a question a project team should investigate.
  5. Water Efficiency: Divide a building's water-use review into indoor and outdoor uses. Add notes for fixtures, irrigation, alternative water sources, metering and leak detection, then identify any terms you still cannot explain.
  6. Energy and Atmosphere: Build a concept map connecting loads, the building envelope, equipment, efficiency, renewable energy and commissioning. Add emissions and refrigerants so your review extends beyond electricity consumption alone.
  7. Materials and Resources: Create separate headings for life-cycle assessment, embodied carbon, product information, reuse and waste prevention. Place a short example under each, checking that you can distinguish the concepts rather than treating them as interchangeable.
  8. Indoor Environmental Quality: Review an imagined occupied room for air quality, daylight and glare, acoustics, thermal comfort and accessibility. Note which information is missing before you suggest an improvement.

After each task, mark the result as “can explain,” “needs reference” or “not yet covered.” Those labels are a study aid, not an official readiness measure. Revisit the weakest explanation before adding more material to an already familiar subject.

How does the old outline differ?

Some official web content still reflects earlier exam preparation. Checked November 5, 2026, USGBC's general exam-preparation landing page displayed an older nine-domain outline alongside v4 and third-edition references. The current September 2026 candidate handbook publishes the eight-domain v5 outline above.

That mismatch matters when you choose a checklist or book. A page's official publisher does not by itself establish that every section matches the current exam. Use the current handbook and the dedicated Green Associate preparation guidance to resolve the version question.

The current handbook's reference list includes the LEED Core Concepts Guide, fifth edition (2026), Foundations of LEED (2023), Guide to LEED Certification: Commercial and LEED Rating System Selection Guidance. A reference's year alone is not the test: confirm whether the current handbook actually lists it.

Before purchasing another resource, compare its stated exam version and domain coverage with that list. You can also review full LEED Green Associate prep, planned for launch, when comparing future preparation options; confirm availability before relying on it for a scheduled exam.

How do you turn the map into preparation?

Create one page with eight rows, using the domain names in the table. For each row, record the reference section you will study, the task you will complete and the concept you need to revisit. Leave no row blank simply because its published count is smaller.

Work through each subject once, then review the gaps your tasks exposed. For a missed practice question, record both the domain and the cause: an unfamiliar term, a confused distinction or difficulty applying the concept. This makes your next session specific without inventing a practice-score cutoff that guarantees readiness.

Before your appointment, reopen the official handbook to confirm the version and specifications still match your materials. If you are selecting an additional resource, check the current availability of full LEED Green Associate prep, planned for launch, before adding it to your study schedule. Your immediate next step is to complete one task in your least familiar domain and use the official references to correct the gaps.

Trust the source

Official sources

Exam policies can change. Use these primary sources for the most current details.